Stamina-products CT2.0 User Manual

Owner's Manual55-1723STAMINA PRODUCTSMADE IN CHINAProduct May Vary SlightlyFrom Pictured.2007, 09Exercise can present a healthrisk. Consult a phy

ASSEMBLY INSTRUCTIONS10STEP 12Install two AA batteries into the METER(33). See page 12 for detailed battery installation instructions.Connect the CONN

SET UP INSTRUCTIONS11Place the CT2.0 CROSS TRAINER in the area where it will be used. It is recommended that the CT2.0CROSS TRAINER be placed on an eq

USING THE METEROpen the Battery Door on the back of the meter.The meter operates with two AA batteries, two batteries included.Refer to the illustrati

13OPERATIONAL INSTRUCTIONEXERCISE WORKOUTTo start using the CT2.0 CROSS TRAINER simply stand on the foot pedals with the front of your shoesclose to t

STORAGE141.2.3.4.To store the CT2.0 CROSS TRAINER simply keep it in a clean dry place.The minimum rest dimensions of the CT2.0 CROSS TRAINER are appro

15CONDITIONING GUIDELINESHow you begin your exercise program depends on your physical condition. If you have been inactive forseveral years or are se

16WARM-UP and COOL-DOWNWarm-up The purpose of warming up is to prepare your body for exercise and to minimize injuries. Warmup for two to five minu

Stamina Products, Inc. warrants that this product will be free from defects in materials and workmanshipunder normal use, service and proper operation

PRODUCT PARTS DRAWING18FRONTBACK

PARTS LIST DIAGRAM# PART NAME QTY19 1 Main Frame 1 2 Front Stabilizer 1 3 Rear Stabilizer 1 4 Left Pedal Arm 1 5 Right Pedal Arm

TABLE OF CONTENTSSafety Instructions 2Before You Begin 4Hardware Identification Chart 5Assembly Instructions 6Set Up Instructions 11Opera

PARTS LIST DIAGRAM# PART NAME QTY2050 Left Pedal Cap 151 Right Pedal Cap 152 Round Plug (35mm) 253 Plastic Washer (M8 x ø18 x 2mm thick)

21NOTES

IMPORTANT : Before filling out the form below make sure you have the right information.Refer to the parts list to make sure you're ordering the

THANK YOU FOR PURCHASING THESTAMINA CT2.0 CROSS TRAINERTo help you get started, we have pre-assembled most of yourCT2.0 CROSS TRAINER at the factory w

BEFORE YOU BEGIN4THE FOLLOWING TOOLS ARE INCLUDED FOR ASSEMBLY : WrenchAllen Wrench (6mm)Right HandlebarUprightMeterLower Pivoting ArmPedal ArmPedal C

Part No. and Description Qty65 Bolt, Button Head (M8 x 1.25 x 15mm) 466 Bolt, Button Head (M8 x 1.25 x 20mm) 267 Bolt, Button Head (M8 x 1.25 x

Place all parts from the box in a cleared area and position them on the floor in front of you. Remove allpacking materials from your area and place

ASSEMBLY INSTRUCTIONS7BracketCable EndSpring HookMetal FittingSTEP 3Refer to the illustration. Slide the CABLE on the TENSION KNOB(32) through the UPR

ASSEMBLY INSTRUCTIONSPlace the front end of the RIGHT PEDAL ARM(5) on the ROLLER(60). Connect the back end of the RIGHTPEDAL ARM(5) to the RIGHT CRANK

ASSEMBLY INSTRUCTIONS9STEP 9: There is a "L" decal on the LEFT HANDLEBAR(7), and a "R" decal on the RIGHT HANDLEBAR(8).To assembl