Stamina-products 55-1539 User Manual

2040 N. Alliance, Springfield, MO 65803Customer Service Number1 (800) 375-7520www.staminaproducts.comThis Product is Produced Exclusively by55-153

OPERATIONAL INSTRUCTIONSGENERAL PRECAUTIONSDo not use the Therapy Inversion System alone. Always have a helper available in case assistance isneeded

OPERATIONAL INSTRUCTIONSHEEL HOLDER USE AND ADJUSTMENTStart by lying fully back on the bed with your hands at your side, or resting on your thighs.Kee

OPERATIONAL INSTRUCTIONS12SUGGESTIONS FOR USEBegin slowly; invert only 15-20 degrees to begin with. Stay inverted only as long as you are comfortable

Stamina Products, Inc. warrants that this product will be free from defects in materials and workmanshipunder normal use, service and proper operation

PRODUCT PARTS DRAWINGBACKFRONT14

15 1 Front Frame 1 2 Rear Frame 1 3 Folding Linkage 2 4 Main Frame 1 5 Left Pivot Arm 1 6 Right Pivot Arm 1 7 Linkage 2 8

16PARTS LIST DIAGRAM# PART NAME QTY47 Bolt, Hex Head (M8 x 1.25 x 20mm) 248 Nylock Nut (M6 x 1) 249 Nylock Nut (M8 x 1.25) 850 Washer (M6

NOTES17

IMPORTANT : Before filling out the form below make sure you have the right information.Refer to the parts list to make sure you're ordering the

TABLE OF CONTENTS Page PageSafety Instructions 2Before You Begin 4Hardware Identification Chart 5Assembly Instructions 6Operational I

THANK YOU FOR PURCHASING THETherapy Inversion SystemTo help you get started, we have pre-assembled most of yourTherapy Inversion System at the factory

BEFORE YOU BEGIN Thank you for choosing the Therapy InversionSystem. We take great pride in producing thisquality product and hope it will provide

5Part No. and Description Qty43 Bolt, Hex Head (M6 x 1 x 42mm) 144 Bolt, Hex Head (M6 x 1 x 47mm) 145 Bolt, Hex Head (M8 x 1.25 x 15mm) 24

ASSEMBLY INSTRUCTIONSPlace all parts from the box in a cleared area and position them on the floor in front of you. Remove allpacking materials from

STEP 4: Attach the FOOTREST(13) onto the HEIGHT ADJUSTMENT BEAM(12) with theADJUSTMENT KNOB(24).NOTE:STEP 5: Insert the HEEL HOLDER TUBE(17) through

ASSEMBLY INSTRUCTIONS1.2.BuckleA.C.B.Buckle8STEP 7Install the HEIGHT ADJUSTMENT BEAM(12) into MAIN FRAME(4) by pulling the SPRING PIN(22)on the MAIN F

ASSEMBLY INSTRUCTIONSShaftShaft9Nylon Bed(10) Handrail(10) HandrailLEFTRIGHTSTEP 13: Verify that the handlebars function correctly before using the T